We're here to help

    BioSig-ID™ Step-by-Step Enrollment

    Follow

    The steps to go through a BioSig-ID™ enrollment, are as follows:

    1. Launch the enrollment process for BioSig-ID™ to get to this screen

      choose_device

    2. Select the device that will be used

      choose_device

    3. Click the `Next` button to proceed

      choose_device

    4. Read and confirm the step-by-step guide

      choose_device

    5. Draw the first four character/number password for BioSig-ID™

      choose_device

    6. Click the `Next` button to continue

      choose_device

    7. The first password is always accepted and now it is important to draw it again as close as possible

      choose_device

      IMPORTANT: It is natural to fail the next step if you are having a difficult time to draw the same characters again close enough to your first password. Try using the `Restart` button otherwise to start fresh and draw something else. For example use an `X` or `7` instead of a `0` as lines are easier than circular motions for some users. Another option is to draw smaller and/or slower. Everything you draw will be used to verify, so if you already know that something went wrong use the `Clear` button to redo the step you are at. Touchpad users might want to consider using both hands to allow more control in drawing while holding down the `left` button.

       

    8. After you are finished drawing it a second time click the `Next` button to continue

      choose_device

    9. To get a proper biometric profile you just have to draw it a third time

      choose_device

    10. After you are finished click the `Next` button to continue

      choose_device

    11. Your primary password for BioSig-ID™ is now enrolled and it is time to create a secondary profile with Click-ID™

      choose_device

    12. This is not an actual keyboard, but an image of one to make it easier to remember what points you click on. It is not a problem to create the same password that was used for the BioSig-ID™ profile, or pick something else (bulls eyes will appear after your selection)

      choose_device

    13. After creating the first profile click on the `Next` button to continue

      choose_device

    14. The first step is always accepted and now it is important to create it again as close as possible

      choose_device

    15. After you are finished creating it again click the `Next` button to continue

      choose_device

    16. Now just once more to finish the Click-ID™ enrollment

      choose_device

    17. Use the `Next` button to continue

      choose_device

    18. This last step will lock everything in place with a final validation of BioSig-ID™

      choose_device

    19. Draw the password you created one final time and click the `Validate` button to continue

      choose_device

    This ends the process and you are now presented with a button to return back to the system you started in before the BioSig-ID™ enrollment (for example Blackboard)

    Was this article helpful?
    17 out of 32 found this helpful